Rotary Switch TROUBLESHOOTING

Check all connections.

Make sure to engage the E-Brake, SWITCH must be in the (H) Position.

Check all connections.

Wires must be connected to the correct wires. Check to see if pins on plugs are bent.

Using a volt meter, test the PURPLE wire, it should read 4.5 volts. Every change on the power levels should show an increase or decrease of 1 volt for each ranging from 4.5volts - 0.5volts. Re-check connections if your volt meter does not show those readings.

You can also use the TEST button on the back of the switch. Push the test button and the test light should light up.

Check your washer with a set pin

For a 6 POSITION switch the set pin should be set in the hole between the 6 & 7

For a 5 POSITION switch the set pin should be set in the hole between the 5 & 6